$100
18" 10/22 barrel. This is a "factory" tapered barrel (no iron sights) that has been reworked by Randy at Connecticut Precision Chambering (CPC). See below for barrel work preformed.
Text Chris at 757-593-4723 for fastest replies.
https://imgur.com/a/2pM6sqk
https://imgur.com/a/jslAqup
https://imgur.com/a/X4ysOTG

BARREL SETBACK & CROWN... Breech end of barrel shank is cut back and lathe re-cut to all correct Ruger dimensions... Setback is normally.250", (.080" for Mannlicher models and 16 1/8 "barrels). Receivers hole is measured and new area on shank is cut to fit hole with a line to line fit to eliminate barrel droop... New extractor groove cut... Chamber is recut to semi-auto match, polished, match bullets lightly engage bore...
Barrel is lapped and 11 degree recessed target crown cut... New V-block spacer is made, fitted so barrel locks in correctly... Ends of blued barrels are cold blued.

Ttp

Up