Hello. I have the following AR Parts up for sale.

I had been planning to build a 300 BLK DPMS Kitty Kat Upper (A1 upper, 7.5" Barrel, FSB) for a while and then my Fiancé surprised me with a new factory build one here recently. I am selling all the parts together as a "kit" if someone would like to build there own. This upper is not assembled, only mocked up. You will need to assemble it/drill the FSB/barrel. Specs below. All of the parts are unfired.

LUTH-AR A1 blem complete upper w/ m4 feed ramps.
7.5" 300BLK Barrel with M4 feed ramps.
Round Aluminum Handguard w/ YHM style barrel nut
Virgin Fulton Armory non f-marked FSB with the front sight post, spring detent installed.
A2 style .30 cal flash hider.
Milspec charging handle.
Pistol gas tube w/ roll pin.
I may have a set of taper pins around but no guarantee.

$220

PSA Freedom 16" Mid Length barrel w/ F marked FSB, barrel nut, etc. Purchased with the intention of having it cut down to 12.5" for a mini dissapator but went another route. Unfired

$130

FTF local to me. I am in Western Loudoun but travel around NoVa Often.

Up

up

up