I have a question that I’m hoping a fellow member can shed some light on. I’ve been building a couple of ARs for the last few years now. I’ve been collecting used parts when possible, and attempting to acquire the hardest to find parts first. Both builds are almost done, and while I’m not currently a stamp collector, I’ve been building these to suppress them in the (hopefully) near future. That brings me to the pickle that I’m in... I went with a Noveske CQB barrel (10.5”) and the almost impossible to find, DD Lite 10 II rail. There was/is absolutely no info on this combo anywhere that I’ve been able to find, so I didn’t know that the rail will most likely keep me from suppressing. I’m planning on putting a Lantac Dragon ASR on, but even with a few shims, there is very little chance that it will work.
Do any of you know of either a suppressor that is thin enough, or a mount that with keep the suppressor far enough away from the rail?
If I knew someone who owns an ASR, I would just go ahead and buy the mount to see if buy chance it works... worst case scenario, the Dragon ASR goes on a 16” lol
It looks like I’ll be using the 10.5” for another build with an NSR 9, so now I just have to find a sub $450 12.5” Crusader to get cut down to 11.5”
...since Noveske only makes a stainless 11.5”.